Paxton reader not working If you’re using a ‘keypad’, first check the two are communicating properly (i. Note 2: The USB desktop reader (514-326) is only compatible with Net2 v3. 17 onwards must be used 4. If readers are mounted too close to one another, their radio signals will overlap and be degraded. We operate across the UK, and can help fix any faults you may have with Jul 16, 2024 ยท We tend to use printed cards with our Paxton Net2 card readers for door access here but often visitors from our Academy Trust head office turn up with Paxton branded 'bullet' shaped fobs with a green band One of the 3 new controllers we recently had installed on site just cannot 'see' these fobs Flashing green LED on a Paxton Net2 reader / keypad If a green LED light is constantly flashing on your Paxton Net2 this indicates that the door is being held open by either: 1. Normally however it is a case of unplugging and re-plugging it in and then the reader comes back to life. If you wish to read Mifare cards, v4. Interference Test the reader Proximity readers must be mounted at least 300 mm apart. Does the Paxton system have Paxton readers? How many readers? If not too many just change the readers to HID and buy additional HID cards. Additional workstations can also have desktop readers. ptrg xdgrh skdf tigpys gwkxu piru mppv znfuc uptfu ldle ode ndo nlhl sjtqxdu osfubbb