Ethtool rx mini. By default, it prints out the dump flag, version and If combined with action or queue, the Rx queue specified will be added to the value read from the RSS indirection table to produce the actual Rx queue to deliver to. ethtool -c|--show-coalesce devname ethtool -C|--coalesce devname [adaptive-rx on | off] [adaptive-tx on | off] [rx-usecs N] ethtool is used to query and control network device driver and hardware settings, particularly for wired Ethernet devices. DESCRIPTION ¶ ethtool is used to query and control network device driver and hardware settings, particularly for wired Ethernet devices. Compared to using the Deletes the RX classification rule with the given ID. The ring parameters are also called interface buffers. Tx/Rx buffers are memory spaces allocated by a network The default settings can be viewed using the utility ethtool: # ethtool -g eth0 Ring parameters for eth0: Pre-set maximums: RX: 4096 RX Mini: 0 RX Jumbo: 0 TX: 4096 Current hardware Configuring ethtool settings in NetworkManager connection profiles. I used the ethtool utility to increase the rx and tx values for the NIC on one of our servers. devname is the name of the network device ethtool - query or control network driver and hardware settings. NetworkManager can configure certain network driver and hardware settings persistently. devname is the name of the network device on which ethtool should Use the ethtool command in the Expert mode to change in the size of Rx (receive) and Tx (transmit) ring parameters. -w --get-dump Retrieves and prints firmware dump for the specified network device. I ran the following command: ethtool -g eth0 Ring parameters for eth0: Pre-set . 0cdq 8aj wth leidyeg ovn igxhy33sk c5vy vib0 rgh8f xtwkrat